#AUSTRALIA POWER PLUG FULL#

Which power plug sockets in Australia In Australia the power plug sockets are of type I. Sometimes electrical device have a switch for either 120-Volt or 230. The standard voltage is 230 V and the frequency is 50 Hz. allow a multi range Voltage (110-240-Volt) and eliminate the need of a Voltage converter. In the 1930s, the predominant Australian electrical accessory manufacturers, along with the State Electricity Commission of Victoria, decided to standardize on Hubbell’s design. In Australia the power plug sockets are of type I. because of its incompatibility with the existing type A plug, but it was favoured in Australia over the British type D system, because it was easier for local manufacturers to make plugs with flat pins rather than round ones. Hubbell’s three-blade design never proved popular in the U.S. Travellers from most nations in Asia, Africa and Europe should have appliances that work on the same mains voltage as. It was patented in 1916 by Harvey Hubbell II, the same electrical engineer who had invented the type A plug. The reason as to why the dimensions of the Australian type I are very similar to those of type A is because the Australasian standard is actually an obsolete type of American plug. Although there are slight differences (the pins of Chinese plugs are 1 mm longer and the sockets are installed with the earth contact facing upwards), the Australian plug mates with the socket used in the People’s Republic of China (mainland China). Australia’s plug/socket system is codified as standard AS 3112. A lower-amperage plug will always fit into a higher-amperage outlet but not vice versa. There is also a 20 amp plug whose prongs are wider still. A standard 10 amp plug will fit into a 15 amp outlet, but a 15 amp plug only fits this special 15 amp socket. Both plug versions have insulated live and neutral pins, so even if the plug is not fully inserted into a socket, touching the exposed part of the prongs can’t give you a shock.Ī plug/socket configuration rated at 15 amps is also available, but the ground pin is wider: 8 mm instead of 6.3 mm.

There is an ungrounded version of this plug as well, with only two flat V-shaped prongs. Manufacturers take these small deviations into account. You can use your electric appliances in Australia, if the standard voltage in your country is in between 220 - 240 V (as is in the UK, Europe, Australia and most of Asia and Africa).

Australia operates on a 230V supply voltage and. In Australia the standard voltage is 230 V and the frequency is 50 Hz. The distance between the centre of the grounding pin and the middle of the plug is 10.3 mm. For Australia the associated plug type is I, which is the plug that has three flat pins in a triangular pattern. The flat earth blade also measures 6.3 by 1.6 mm, but it is 20 mm long. Their centres are spaced 13.7 mm apart and both prongs measure 17.3 mm in length and 6.3 mm in width. This 10 amp plug has two flat 1.6 mm thick blades, set at 30° to the vertical, forming an upside-down V.

#AUSTRALIA POWER PLUG FULL#

(Click here for the full list of all countries that use type I) Type I is mainly used in Australia, New Zealand, Papua New Guinea, China and Argentina.

Australia power plug